Tale of two boats – Haines Signature 485SF and 543Sf Reviewed (Part 2)

Join us for part 2 of Scott Mitchells boat review where he covers the Haines Hunter 543SF. Bigger is always better – right?

File 26-04-2016, 5 41 02 PM

The Haines Signature 485 sf is now the company’s largest selling sport fishing (SF) model. Having such a diverse range of fisheries surrounding us in Hervey Bay, it’s a challenge to find a boat that covers everything with every boat being a compromise. The 485SF was a versatile boat with an emphasis on inshore fishing and the capability of running offshore when conditions allowed.

Over the last 10 years living in Hervey Bay I found I was spending more and more time out in open water fishing as far as 30 miles off the top of Fraser Island and the Southern gutters which signal the bottom of the Great Barrier Reef. So the decision was made to get a larger boat more suited to safely fishing offshore with my priorities in reverse. But I still wanted to fish shallow flats, creeks, rivers and our larger impoundments for bass and barra on occasion.

File 26-04-2016, 5 46 54 PM

There no question that size “does” matter when dealing with rough open water and we were looking for a little more comfort as we are getting older – some may say softer!

What I really wanted was a larger Signature 485sf. I spoke with the team at Haines Group again and suggested there was an opportunity for an Australian fibreglass boat manufacturer to build a “specialised” sportfishing centre console to suit our local fishing styles and compete with the international imports. After quite a lot of discussion it was decided that the Signature 543 was the right hull for the job with a well proven sea handling reputation and was a great length to be handled easily either on your own or with a few mates – but needed a new deck for sportfishing.

Danish born Australian adventurer Hans Tholstrup undertook the impossible and completed an extraordinary expedition and one of the greatest small boat ocean voyages of all time in a stock standard Haines Signature 540 powered by a 90hp engine. Hans completed the 7,500 km odyssey from Darwin to Okinawa, Japan back in 1999. Our Signature 543sf is a third generation on that hull with time proven sea legs!

So begun the 543SF project. We drew up the general deck design with the key features. Starting at the bow there is a deep anchor well large enough to carry at least 110m of rope with suitable chain and anchor. There is a custom-made electric motor plate which can be mounted on either the port or starboard side to suit your preference. Being right handed, I prefer mine on the starboard side so I’m not casting over the Minn Kota when it’s not deployed. We went with a Minn Kota Terrova iPilot 24 volt 80lb bow mount with 60-inch shaft this time round.

File 26-04-2016, 5 48 37 PM

The front casting deck is large enough to sleep two people comfortably, making it ideal for long range trips. I wanted at least one large dry storage compartment which caused some debate in relation to the definition of “dry”. John Haines Jnr said very few deck storage options can truly be classified as completely dry, however, the use of a deep hatch track and seal would provide sufficient waterproofing for most. We settled on having two split hatches towards the bow deep enough to house any items you would prefer to keep dry – safety gear, jackets, bedding, cooking gear etc. The hatches have been fitted with gas struts for ease of opening and to hold these up when open.

Next was a kill tank/live well. The one we had previously in our 485SF was fantastic so we elected to reproduce it again – only with a little more depth this time due to the increased height of the raised casting deck. This compartment has been foam lined to improve insulation as both a live well or kill tank and will hold ice for day/overnight trips. It makes a fantastic live storage well for species such as bream, flathead, whiting and bass and will keep them in top condition until either released or dispatched for eating. It carries approx. 120 litres of water.

File 26-04-2016, 5 48 04 PM
File 26-04-2016, 5 40 42 PM

Next we have another large general storage compartment with two access hatches that are ideal for storing long items like gaffs, folding nets, lure retrievers, drogue, and tackle boxes. There’s a deep bilge sump below the floor with plumbing for the live well and deck wash system flush mounted into the port side.

A lot of thought and design has gone into the centre console. Anyone who’s fitted electronics in centre consoles previously will appreciate the hinged folding top section! With sounder screens getting larger every year the dash section will accommodate flush mounted screens in excess of 12-inches. I am running the latest Lowrance HDS Gen 3 Touch units with a Touch 9 as my GPS/charting unit and a Touch 12 for sonar and 3D Structure scan. Both units are networked so you can accurately mark bottom structure as a waypoint or split the screens as desired. I also added the new Sonar Hub with CHIRP transducer and saltwater Hydrowave H2 unit.

File 26-04-2016, 5 47 23 PM

I mounted a Lowrance Sonic Hub for playing a few tunes on the longer runs or overnight trips. There are two Lowrance LMF 400 gauges to read all the engine data and fuel management details via an interface to the engine. We also fitted the Suzuki Troll Mode system which allows the engine’s revs to be adjusted in 50rpm intervals simply by pressing the Troll Mode control switch from idle up to1200rpm. I also went with the Lowrance Link 8 DSC VHF radio with a short whip antenna.

Everything on the console is ergonomically positioned for easy access. The Bennett trim tab switches are positioned just above the single binnacle control box so the boat can be easily trimmed while running. All the switches for lights, bilges, live wells, and deck wash are positioned across the dash directly in front of the steering wheel, which is also on an adjustable tilt helm. There is a Sterling Pro Mariner three bank (30 amp) battery charger mounted under the console, hard wired into the two Deka marine Intimidator 8A31 batteries for the 24 volt Minn-Kota system as well as the third Deka house battery to run all the other electronics. This makes charging all the batteries painless by just running a lead to the boat and plugging it into the Clipsal power plug on the side of the console. I also had a separate C-Tek MXS 5 maintenance charger hard wired into the Deka crank battery down the back.

File 26-04-2016, 5 40 15 PM

There are three rod racks built into each side of the boat’s gunwales with individual tubes to protect rods up to 12 feet, making it ideal for both conventional and fly rods. Soft cushioned coamings have been fitted in the main cockpit area for added comfort when fishing heavier tackle and battling larger fish. Behind the console there’s a comfortable boat seat with storage built in under the cushion. There’s enough space underneath the seat to fit a larger cooler or tackle bags. There’s also a removable padded back rest with another four rod holders built into it.

The transom area features a small seat on each side which houses the main crank battery, charger and isolator switches on the port side with a plumbed live well on the starboard side.

File 26-04-2016, 5 40 28 PM

The hull is rated up to 150hp with our choice of motor being the Suzuki DF140A. We couldn’t be happier with the performance and have propped the boat for midrange fuel economy by running a Suzuki stainless steel 3 x 13 7/8 x 21 R prop. This combination gets out of the hole well, while offering a cruising speed of about 20 knots and burning 15 litres per hour at 4000 RPM. This gives the boat great range with the underfloor 160 litre fuel tank. WOT at 6000 rpm produces 36 knots, burning 45 litres per hour. I am looking at trying a Solas 4 blade prop next as everything I have researched suggest that the right one should give me even better whole shot and cruise speed as I am most interested in fuel economy rather than top end speed.

The whole rig comes in at about 1800kgs sitting on a tandem axle Dunbier wide body Supa Rolla trailer with sexy alloy wheels.

File 26-04-2016, 5 39 46 PM

We feel very privileged to be given the opportunity to work with The Haines Group and believe the 543SF will gain legend status around fishing circles in years to come. It has set a new benchmark with everyone who has had a run with us commenting on the ride quality and layout and we couldn’t be happier with just on 500 faultless hours now up on the 140 Suzuki.

Being locally manufactured by our country’s largest fibreglass trailer boat company you have the flexibility of customising the your whole package as well with a number of options available including a tiller steer, sporty side console and our fully optioned centre console models all being available in a range of classy gel coat colours.

Scott Mitchell

About Scott Mitchell

I have been fishing since I was 8 years old – some say obsessed. Originally from the Illawarra, just south of Sydney NSW Australia. I grew up fishing for anything with fins (and sometimes without). I have many fond memories of fishing in Lake Illawarra ,Warilla Beach , Barrack point, Bass point and from the front of Windang Island as a kid. I spent my teenage years land based game fishing from just about every ledge along the NSW coast from Coffs Harbour in the North to Green Cape in the South. Some of the most memorable fishing I have done to date was on the stones doing battle with large tuna and marlin.I picked up my first fly rod in 1989 - a #9wht outfit which I used to catch tailor , salmon, frigates, luderick, bream etc while waiting for a run on the big gear. I now enjoy fly fishing when ever the oppertunity arrises with over 150 species on the long wand to date. http://www.scotto.com.au/

Previous Know Your Crab Pots
Next Whiting Wisdom

You might also like

Boating Talk

Quintrex Dory Blade 520 + Yamaha F60hp 4-Stroke boat review

Looking for a tinnie great for crab fishermen and large tinnie fans out there because this is the king of all ninnies….

Boating Talk

Lowrance Launches NEW NAIS500 Class-B AIS

Lowrance®, a world-leader in fishing electronics since 1957, announced today, a fully integrated, Class-B Automatic Identification System (AIS) transponder – the Lowrance NAIS 500.

Boating Product Talk

Boat Review Baysport 600 Offshore + Yamaha F130hp 4-stroke

Baysport are a locally made Fibreglass boat, made by the same man up in Noosa for almost 30 years. Baysport are the biggest selling Fibreglass boat in Queensland for 7 years in a row!…..

0 Comments

No Comments Yet!

You can be first to comment this post!

Leave a Reply

Prove you are human * Time limit is exhausted. Please reload CAPTCHA.